Marbles or small balls
About 6 feet of flexible tubing, such as ¾-inch foam pipe insulation
Various supports, such as boxes, paper towel tubes or books
Cut the tubing in half. This doubles the amount of “track” for the roller coaster.
Your “car” (the marble) needs kinetic energy at the beginning of the roller coaster so that it can make it through the entire course. How should the tubing for the beginning of the roller coaster be positioned? Use tape and various supports to create the starting point.
Use the tubing, tape and supports to build the rest of your roller coaster. Try to include at least one loop, hill and jump.
Put the plastic cup at the end of the course. The challenge is to get the marble to land in the cup.
Place your marble at the beginning of your roller coaster and let it go. Did it work? Figure out what went wrong, and make adjustments to your course as needed.
Try this - Once you get your roller coaster to work, try starting the coaster at a higher point and see what happens. Try a different design by adding more loops, hills or curves to your course.
A roller coaster demonstrates kinetic energy and potential energy. A marble at the top of the track has potential energy. When the marble rolls down the track, the potential energy is transformed into kinetic energy. Real roller coasters use a motor to pull cars up a hill at the beginning of the ride. Cars that are stopped at the top of the hill have potential energy. As the car rolls down the hill, the potential energy becomes kinetic energy.
© 2014 Museum of Science and Industry, Chicago – All rights reserved.
Visit the Museum of Science and Industry online! http://www.msichicago.org